Info
Facts about the machine:
|
|
Plotter Setup
Before trying to get things working, determine the following:
- Decide what interface to use, and make sure to use the correct cables.
- If using USB, install the USB-driver from the supplied CD.
- Check what baudrate the cutter is setup to use.
- Check that the cutting-head is not against any of the red- buttons.
- Make sure the machine is powered on and in online-mode.
SignCut-X2 Windows Setup
To setup SignCut-X2 for your machine, follow these steps:
- Open SignCut-X2.
- Click on the Cutter- button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that should be a COM-port or "Creation USB" for the USB-cable.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
SignCut-X2 Mac Setup
To setup SignCut-X2 for your machine, follow these steps:
- Open SignCut-X2.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that begins with "/dev/cu.", or "Creation USB" for the USB-cable.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
If you need help in order to get the machine up and running, we offer
hardware and software support by clicking here.
YES
NO
