Info
Facts about the machine:
|
|
Plotter Setup
Before trying to get things working, determine the following:
- Decide what interface to use, and make sure to use the correct cables.
- Check what baudrate the cutter is setup to use.
- Align the vinyl and make sure the pinch-rollers are set correctly.
- Make sure the machine is powered on and in online-mode.
SignCut-X2 Windows Setup
To setup SignCut-X2 for your machine, follow these steps:
- Open SignCut-X2.
- Click on the Cutter- button to open that dialogue.
- In the Manufacturer list, choose "Roland DG".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that should be either a COM-port or LPT-port. If you have installed a windows-driver for your machine, choose the name of that printer-driver in this list instead.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
SignCut-X2 Mac Setup
To setup SignCut-X2 for your machine, follow these steps:
- Open SignCut-X2.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Roland DG".
- In the Cutter list, choose your particular model.
- On Mac you need to use a USB to serial adapter, we recommend Keyspan. Install the driver for your adapter.
- In the Device list, choose a device that begins with "/dev/cu." that is not a bluetooth adapter or similar. Usually it's named keyspan or serial.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
If you need help in order to get the machine up and running, we offer
hardware and software support by clicking here.
YES
NO
